Gen V LT Cam Swap Guide

One checklist for the cam, valvetrain, gaskets, sealants, fluids and torque-to-yield fasteners.

Job order, access notes and the places where unnecessary teardown creates more work.

Timing position, phaser seating, correct early Gen V hardware and final verification.

Cam base-circle method, zero-lash measurement, preload selection and rocker torque.

Measure the installed cam and pump combination instead of choosing a lash cap from lobe percentage alone.

Alignment, sealing surfaces, fastener groups and tightening direction.

Seal replacement, sizing, installation protection and checks before the rail goes back on.

A practical stock-module retrofit covering the pump, venturi supply, wiring and hose routing.

Prime, inspect, start, monitor and recheck before calling the job complete.